BASE jumper dies after 700ft wingsuit failure in Utah
Summarised from 4 outlets · 5 reports · Updated 29 Sept, 14:25 · Archive
A 27-year-old BASE jumper died in Utah after his wingsuit failed during a 700ft jump.
A 27-year-old BASE jumper died on Sunday after his wingsuit failed during a jump from a 700ft cliff in northern Utah. The Mirror identifies him as Gabe Reilly, a firefighter. Officials said he did not have enough lift with his wingsuit.

How it is being reported
- BASE jumper who died in 700-foot cliff jump ID’d as ‘free-spirited’ firefighter, 27The jumper “did not have enough lift with his wingsuit,” officials said.New York Post · 29 Sept, 13:51
- Firefighter, 27, plunges 700ft to his death near Millville Canyon as wingsuit failsGabe Reilly, a 27-year-old firefighter and BASE jumper, died on Sunday after his wingsuit failed during a jump from a 700ft height in northern UtahThe Mirror · 29 Sept, 13:17
- BASE jumper, 27, dies in leap off 700-foot cliff: ‘Something went wrong’“He impacted the ground at a high rate of speed resulting in his death.”New York Post · 28 Sept, 18:34
- BASE jumper dies after falling from 700-foot Utah cliffA 27-year-old BASE jumper died on Sunday, after falling about 700 feet from a cliff in Utah, authorities said.CBS News · 28 Sept, 16:44
- Base jumper dies in Utah after wingsuit fails in remote mountainous regionIdentity of man, 27, being withheld pending family notification after 700ft plunge A Base jumper died on Sunday in Utah after his wingsuit failed while he plunged from a 700ft height, according to authorities. Local news reports cited the Cache county sheriff’s office, which said that the man fell to his death at age 27 in a mountainous region of Hyrum, which is east from the city of Millville. Continue reading...Guardian World · 28 Sept, 14:28
In this story: Gabe Reilly · Cache County · Utah · Hyrum · Millville
This summary was written by AI from the headlines and standfirsts above, and states as fact only what at least two outlets report. How we use AI · Report a problem · Corrections log
Comments (0)